Epson AcuLaser C1100 Service Manual page 500

EPSON AcuLaser C1100
2nd BTR Offset
Normal : Setting value of the transfer voltage for plain paper.
SemiThk : Setting value of the transfer voltage for High quality
paper.
Thick : Setting value of the transfer voltage for thick paper.
ExtraThk : Setting value of the transfer voltage for Extra thick
paper.
Card : Setting value of the transfer voltage for postcard
paper.
Envelope : Setting value of the transfer voltage for envelope.
:
Power On Number of times power is turned on.
:
Sleep Number of times printer returns from standby mode.
Engine Version
MCU : Firmware version of mechanical controller.
Duplex : Firmware version of the Duplex unit.
Error Log : Displays the latest 20 errors listing in order of the
number of pages with the largest one first. The
description for each error consists of; the panel
message, the EJL status code, the number of printed
sheets, the jam code, the paper size, and the paper
type.
Service call errors which occurred after the Ready
mode and jam errors are included.
The errors with the same total pages as a previously
recorded error are not included.
Jam code : The location of the jam is indicated by 8-digit
hexadecimal strings as bit data.
MAINTENANCE
Bit
31-24
23
22
21
20
19
18
17
16
15
14
13
12
11
10
9
8
7
6
5
4
3
2
1
0
Sheet for Servicing
Table 6-1. Jam code
Location of jam
---
At Exit sensor
At Fuser In sensor
At Regi sensor
At OHP sensor
At Tray Path1 sensor
At Tray Path2 sensor
At Dup In sensor
At Dup Out sensor
After Exit sensor turns off, Dup In sensor does not turn off
After Dup In sensor turns on, Dup Out sensor stays off
After Duplex loading signal, Regi sensor stays off
After Regi sensor turns off, Exit sensor stays off
After Regi Roll turns on, Exit Fuser In sensor stays off
---
The setting is for transparency, but media other than transparencies
was fed. The setting is for other than transparency, but transparencies
were fed.
---
After Regi Roll turns on, Exit sensor stays off. Fuser In sensor off
After Regi Roll turns on, Exit sensor is stays off. Fuser In sensor on
After Regi Roll turns on, Regi sensor stays on
Regi sensor signal from cassette 1 or 2 is not received.
Regi sensor signal from MP tray is not received.
Tray Path1 sensor signal from cassette 1 is not received.
(Tray Path1 sensor signal from cassette 2) is not received.
(Tray Path2 sensor signal from cassette 2) is not received.
Revision B
500