List Of Service Request - Epson AcuLaser C1100 Service Manual

EPSON AcuLaser C1100

3.3.2 List of Service Request

Class Panel Messaeg
Service Req E510
Service Req E511
Service Req E513
Service Req E514
Service Req E516
Service Req E517
Service Req E520
Service Req E521
Service Req E523
Service Req E524
Service Req E525
Service Req E526
TROUBLESHOOTING
Table 3-3. List of Service Request
ROS Motor Failure
PWBA MCU could not receive signals output from SOS Sensor in ROS within the specified time.
TR0 Failure
PWBA MCU could not receive signals output from SENSOR TR-0 (TR0 Sensor) at the specified timing.
NVRAM Error
An error occurred in NVRAM on PWBA MCU.
PAGE Timeout
The PAGEC/PAGE signal was not received within 60sec after transmitting PFA.
Communication Error Duplex
A communication error occurred between PWBA MCU and Duplex.
Communication Error Feeder
A communication error occurred between PWBA MCU and Feeder.
BTR 2 Advance Error
The 2nd BTR Retract Sensor does not turn ON within the specified time.
BTR 2 Error
The input of 2nd BTR Retract Sensor does not change when 2nd BTR is initialized.
PCDC Error
PCDC is not functioning normally.
Low Density
The output value of SENSOR ASSY ADC (ADC Sensor) is below the specified value.
High Density
The output value of SENSOR ASSY ADC (ADC Sensor) exceeds the specified value.
ADC Contamination
SENSOR ASSY ADC (ADC Sensor) error
FIP according to the printer message
Description
Revision B
See FIP
44 (p.197)
43 (p.195)
42 (p.194)
41 (p.194)
40 (p.193)
39 (p.192)
52 (p.208)
51 (p.206)
49 (p.204)
48 (p.202)
47 (p.200)
46 (p.199)
130