Motor Assy Dup - Epson AcuLaser C1100 Service Manual

EPSON AcuLaser C1100

4.12.26 MOTOR ASSY DUP

REMOVAL
1. Remove DUPLEX ASSY. (p.412)
2. Remove COVER-L DUP. (p.414)
3. Unclamp the clamp on BKT MOTOR DUP TRANS, and remove the harness.
4. Disconnect connector (P/J444) from PWBA DUP-L.
5. Remove the 4 screws (silver, with flange, tapping, 10 mm) fastening BKT
MOTOR DUP TRANS to DUPLEX ASSY.
When performing the following work, take care not to remove
C A U T I O N
DUPLEX ASSY and BKT MOTOR DUP TRANS too far as
they are connected by a harness.
When performing the following work, take care not to drop or
lose gears, and other parts.
6. Remove BKT MOTOR DUP TRANS from DUPLEX ASSY together with PWBA
DUP-L and MOTOR ASSY DUP.
7. Unclamp the clamp, and disconnect connector (P/J442) of MOTOR ASSY DUP
on PWBA DUP-L.
8. Remove the 4 screws (silver, 5mm) fastening MOTOR ASSY DUP to BKT
MOTOR DUP TRANS.
9. Remove MOTOR ASSY DUP from BKT MOTOR DUP TRANS.
DISASSEMBLY AND ASSEMBLY
3)
4)
5)
5) 5)
5)
Figure 4-143. Removal of MOTOR ASSY DUP (1)
DUPLEX
Revision B
6)
Leg_Sec03_128FB
443