EPSON EPL-N2050
4.2.80 Harness Assy DUP-M
4.2.80.1 Removal
1. Remove the Cover Assy Front (Section 4.2.3).
2. Remove the Cover Front L/H (Section 4.2.5).
3. Remove the Cover Rear (Section 4.2.12).
4. Remove the Fuser Assy (Section 4.2.55).
5. Remove the Cover Assy I/F (Section 4.2.2).
6. Remove the Cover Left (Section 4.2.1).
7. Remove the Cover Assy Top (Section 4.2.7).
8. Remove the Chute MBF Assy (Section 4.2.30).
9. Remove the Shaft 14 (Section 4.2.51).
10. Remove the Gear 14 (Section 4.2.51).
11. Remove the P/H Assy (Section 4.2.42).
12. Remove the Chute Trans Assy (Section 4.2.54).
13. Remove the Plate Assy Left (Section 4.2.70).
14. Remove the CRU Top Guide Assy (Section 4.2.65).
15. Remove the Plate Handle (Section 4.2.72).
16. Remove the PWBA MCU (Section 4.2.83).
17. Remove the Motor Assy Main (Section 4.2.68).
18. Remove the PWBA PS (Section 4.2.85).
19. Remove the Gear Assy Drive (Section 4.2.67).
20. Unplug the connector (P/J34) from the PWBA MCU.
Disassembly and Assembly
NOTE: In the following steps, do not detach the Harness Assy DUP-M
and the printer far away because they are connected with the
harness.
21. Remove the two screws securing the Harness Assy DUP-M to the printer.
22. Detach the harness of Harness Assy DUP-M a little from the printer.
23. Draw the harness of Harness Assy DUP-M from the hole in the printer.
Figure 4-100. Removal of Harness Assy DUP-M
Disassembly and Assembly
Revision B
198