Ip Admission - Cisco Catalyst 2960 Command Reference Manual

ip admission

ip admission
To use this command, the switch must be running the LAN Base image.
Note
Use the ip admission interface configuration command to enable web authentication. You can also use
this command in fallback-profile mode. Use the no form of this command to disable web authentication.
Syntax Description rule
Command Modes Global configuration
Command History Release
12.2(35)SE
Usage Guidelines The ip admission command applies a web authentication rule to a switch port.
Examples
This example shows how to apply a web authentication rule to a switchport:
Switch# configure terminal
Switch(config)# interface gigabitethernet0/1
Switch(config-if)# ip admission rule1
This example shows how to apply a web authentication rule to a fallback profile for use on an
IEEE 802.1x enabled switch port.
Switch# configure terminal
Switch(config)# fallback profile profile1
Switch(config)# ip admission name rule1
Switch(config)# end
Related Commands Command
dot1x fallback
fallback profile
Catalyst 2960 Switch Command Reference
2-122
ip admission rule
no ip admission
Apply an IP admission rule to the interface.
Modification
This command was introduced.
Description
Configure a port to use web authentication as a fallback method for clients
that do not support IEEE 802.1x authentication.
Enable web authentication on a port
Chapter 2 Catalyst 2960 Switch Cisco IOS Commands
OL-8604-04