Show Mvr Members - Cisco Catalyst 2960 Command Reference Manual

Hide thumbs Also See for Catalyst 2960:

Table of Contents

show mvr members

To use this command, the switch must be running the LAN Base image.

Use the show mvr members privileged EXEC command to display all receiver and source ports that are

currently members of an IP multicast group.

Syntax Description

Command Modes

Privileged EXEC

Command History

Usage Guidelines

The show mvr members command applies to receiver and source ports. For MVR-compatible mode, all

source ports are members of all multicast groups.

Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output

do not appear, but the lines that contain Output appear.

This is an example of output from the show mvr members command:

Switch# show mvr members

MVR Group IP

------------

239.255.0.10

Catalyst 2960 Switch Command Reference

show mvr members [ip-address] [ | {begin | exclude | include} expression]

(Optional) The IP multicast address. If the address is entered, all receiver and

source ports that are members of the multicast group appear. If no address is

entered, all members of all Multicast VLAN Registration (MVR) groups are

listed. If a group has no members, the group is listed as Inactive.

(Optional) Display begins with the line that matches the expression.

(Optional) Display excludes lines that match the expression.

(Optional) Display includes lines that match the specified expression.

Expression in the output to use as a reference point.

Modification

This command was introduced.

Chapter 2 Catalyst 2960 Switch Cisco IOS Commands

Gi0/1(d), Gi0/5(s)