Cisco Catalyst 2960 Command Reference Manual page 714

debug platform tcam
search
write {forw-ram | reg |
tcam}
Though visible in the command-line help strings, the l3 ipv6 {acl {input | output} | local | qos |
Note
secondary}, the l3 local, and the l3 secondary keywords are not supported.
Defaults
Debugging is disabled.
Command Modes Privileged EXEC
Command History Release
12.2(25)FX
Usage Guidelines The undebug platform tcam command is the same as the no debug platform tcam command.
Related Commands Command
show debugging
Catalyst 2960 Switch Command Reference
B-50
Display supervisor-initiated TCAM-search results debug messages.
Display TCAM-write debug messages. The keywords have these
meanings:
forw-ram—Display forwarding-RAM write debug messages.
reg—Display TCAM-register write debug messages.
tcam—Display TCAM-write debug messages.
Modification
This command was introduced.
Description
Displays information about the types of debugging that are enabled.
Appendix B Catalyst 2960 Switch Debug Commands
OL-8604-04