Cisco Catalyst 2960 Command Reference Manual page 488

Chapter 2 Catalyst 2960 Switch Cisco IOS Commands
Table 2-30
Field
BrdgNo
Stp
BrdgMode
Trans1
Trans2
Remote SPAN VLANs
Primary/Secondary/
Type/Ports
This is an example of output from the show vlan summary command:
Switch> show vlan summary
Number of existing VLANs
Number of existing VTP VLANs
Number of existing extended VLANs : 0
This is an example of output from the show vlan id command.
Switch# show vlan id 2
VLAN Name
---- -------------------------------- --------- -------------------------------
2
VLAN Type
---- ----- ---------- ----- ------ ------ -------- ---- -------- ------ ------
2
Remote SPAN VLAN
----------------
Disabled
Related Commands Command
switchport mode
vlan (global
configuration)
vlan (VLAN
configuration)
OL-8604-04
show vlan Command Output Fields (continued)
Description
Bridge number for the VLAN, if applicable.
Spanning Tree Protocol type used on the VLAN.
Bridging mode for this VLAN—possible values are source-route bridging
(SRB) and source-route transparent (SRT); the default is SRB.
Translation bridge 1.
Translation bridge 2.
Identifies any RSPAN VLANs that have been configured.
—
VLAN0200
SAID MTU
enet 100002 1500
Description
Configures the VLAN membership mode of a port.
Enables VLAN configuration mode where you can configure VLANs 1 to
4094.
Configures VLAN characteristics in the VLAN database. Only available for
normal-range VLANs (VLAN IDs 1 to 1005). Do not enter leading zeros.
: 45
: 45
Status Ports
active Gi0/1, Gi0/2
Parent RingNo BridgeNo Stp
- - -
Catalyst 2960 Switch Command Reference
BrdgMode Trans1 Trans2
- - 0 0
show vlan
2-461