Cluster Outside-Interface - Cisco Catalyst 2960 Command Reference Manual

Hide thumbs Also See for Catalyst 2960:

Table of Contents

Catalyst 2960 Switch Cisco IOS Commands

cluster outside-interface

Use the cluster outside-interface global configuration command to configure the outside interface for

cluster Network Address Translation (NAT) so that a member without an IP address can communicate

with devices outside the cluster. Use the no form of this command to return to the default setting.

Syntax Description

interface-id

The default outside interface is automatically selected by the cluster command switch.

Command Modes

Global configuration

Command History

Usage Guidelines

Enter this command only on the cluster command switch. If you enter this command on a cluster member

switch, an error message appears.

This example shows how to set the outside interface to VLAN 1:

Switch(config)# cluster outside-interface vlan 1

You can verify your setting by entering the show running-config privileged EXEC command.

Related Commands

show running-config

cluster outside-interface interface-id

no cluster outside-interface

Modification

This command was introduced.

Interface to serve as the outside interface. Valid interfaces include

physical interfaces, port-channels, or VLANs. The port-channel

range is 1 to 6. The VLAN range is 1 to 4094.

Displays the current operating configuration. For syntax information,

select the Cisco IOS Configuration Fundamentals Command

Reference, Release 12.2 > File Management Commands >

Configuration File Management Commands.

Catalyst 2960 Switch Command Reference

cluster outside-interface