Cisco Catalyst 2960 Command Reference Manual page 633

Hide thumbs Also See for Catalyst 2960:

Table of Contents

Chapter 2 Catalyst 2960 Switch Cisco IOS Commands

This example shows how to rename the filename for VTP configuration storage to vtpfilename:

Switch(config)# vtp file vtpfilename

This example shows how to clear the device storage filename:

Switch(config)# no vtp file vtpconfig

Clearing device storage filename.

This example shows how to specify the name of the interface providing the VTP updater ID for this

Switch(config)# vtp interface gigabitethernet

This example shows how to set the administrative domain for the switch:

Switch(config)# vtp domain OurDomainName

This example shows how to place the switch in VTP transparent mode:

Switch(config)# vtp mode transparent

This example shows how to configure the VTP domain password:

Switch(config)# vtp password ThisIsOurDomain'sPassword

This example shows how to enable pruning in the VLAN database:

Switch(config)# vtp pruning

Pruning switched ON

This example shows how to enable Version 2 mode in the VLAN database:

Switch(config)# vtp version 2

You can verify your settings by entering the show vtp status privileged EXEC command.

Related Commands

configuration)

Displays the VTP statistics for the switch and general information about the

VTP management domain status.

Configures VTP domain-name, password, pruning, version, and mode.

vtp (global configuration)

Catalyst 2960 Switch Command Reference