Cisco Catalyst 2960 Command Reference Manual page 607

Hide thumbs Also See for Catalyst 2960:

Table of Contents

Chapter 2 Catalyst 2960 Switch Cisco IOS Commands

This example shows how to enable UDLD on all fiber-optic interfaces:

Switch(config)# udld enable

You can verify your setting by entering the show udld privileged EXEC command.

Related Commands

The no udld port interface configuration command followed by the udld port or udld port

aggressive interface configuration command to re-enable UDLD on the specified interface

The errdisable recovery cause udld and errdisable recovery interval interval global

configuration commands to automatically recover from the UDLD error-disabled state

Displays UDLD administrative and operational status for all ports

or the specified port.

Enables UDLD on an individual interface or prevents a fiber-optic

interface from being enabled by the udld global configuration

Resets all interfaces shut down by UDLD and permits traffic to

again pass through.

Catalyst 2960 Switch Command Reference