Sdm Prefer - Cisco Catalyst 2960 Command Reference Manual

sdm prefer

sdm prefer
Use the sdm prefer global configuration command to configure the template used in Switch Database
Management (SDM) resource allocation. You can use a template to allocate system resources to best
support the features being used in your application. Use the no form of this command to return to the
default template.
Syntax Description default
qos
Defaults
The default template provides a balance to all features.
Command Modes Global configuration
Command History Release
12.2(25)FX
Usage Guidelines You must reload the switch for the configuration to take effect.
If you enter the show sdm prefer command before you enter the reload privileged EXEC command, the
show sdm prefer command shows the template currently in use and the template that will become active
after a reload.
Use the no sdm prefer command to set the switch to the default desktop template.
Table 2-15
Table 2-15
Resource
Unicast MAC addresses
IPv4 IGMP groups
IPv4 MAC QoS ACEs
IPv4 MAC security ACEs
Catalyst 2960 Switch Command Reference
2-282
sdm prefer {default | qos}
no sdm prefer
Give balance to all functions.
Provide maximum system usage for quality of service (QoS) access control
entries (ACEs).
Modification
This command was introduced.
lists the approximate numbers of each resource supported in each template.
Approximate Number of Feature Resources Allowed by Each Template
Chapter 2 Catalyst 2960 Switch Cisco IOS Commands
Default QoS
8 K 8 K
256 256
128 384
384 128
OL-8604-04