Ip Admission - Cisco Catalyst 2960 Command Reference Manual

Chapter 2 Catalyst 2960 Switch Cisco IOS Commands

ip admission

Use the ip admission interface configuration command to enable web authentication. You can also use
this command in fallback-profile mode. Use the no form of this command to disable web authentication.
Syntax Description rule
Command Modes
Global configuration
Command History Release
12.2(35)SE
Usage Guidelines
The ip admission command applies a web authentication rule to a switch port.
Examples This example shows how to apply a web authentication rule to a switchport:
Switch# configure terminal
Switch(config)# interface gigabitethernet0/1
Switch(config-if)# ip admission rule1
This example shows how to apply a web authentication rule to a fallback profile for use on an
IEEE 802.1x enabled switch port.
Switch# configure terminal
Switch(config)# fallback profile profile1
Switch(config)# ip admission name rule1
Switch(config)# end
Related Commands Command
dot1x fallback
fallback profile
ip admission name
proxy http
show ip admission
OL-8604-03
ip admission rule
no ip admission
Apply an IP admission rule to the interface.
Modification
This command was introduced.
Description
Configure a port to use web authentication as a fallback method for clients
that do not support IEEE 802.1x authentication.
Enable web authentication on a port
Enable web authentication globally on a switch
Displays information about NAC cached entries or the NAC configuration.
For more information, see the
Configuration Guide
Network Admission Control Software
on Cisco.com.
Catalyst 2960 Switch Command Reference
ip admission
2-123