Show Interfaces - Cisco Catalyst 2960 Command Reference Manual

show interfaces

show interfaces
Use the show interfaces privileged EXEC command to display the administrative and operational status
of all interfaces or a specified interface.
Syntax Description interface-id
vlan vlan-id
accounting
capabilities
module number
counters
description
etherchannel
flowcontrol
pruning
stats
status
err-disabled
switchport
backup
transceiver
[detail |
properties]
Catalyst 2960 Switch Command Reference
2-350
show interfaces [interface-id | vlan vlan-id] [accounting | capabilities [module number] |
counters | description | etherchannel | flowcontrol | pruning | stats | status [err-disabled] |
switchport [backup | module number] | transceiver properties | detail [module number] |
trunk] [ | {begin | exclude | include} expression]
(Optional) Valid interfaces include physical ports (including type, module, and
port number) and port channels. The port-channel range is 1 to 6.
(Optional) VLAN identification. The range is 1 to 4094.
(Optional) Display accounting information on the interface, including active
protocols and input and output packets and octets.
The display shows only packets processed in software; hardware-switched
Note
packets do not appear.
(Optional) Display the capabilities of all interfaces or the specified interface,
including the features and options that you can configure on the interface. Though
visible in the command line help, this option is not available for VLAN IDs.
(Optional) Display capabilities, switchport configuration, or transceiver
characteristics (depending on preceding keyword) of all interfaces on the switch.
The only valid module number is 1. This option is not available if you enter a
specific interface ID.
(Optional) See the
(Optional) Display the administrative status and description set for an interface.
(Optional) Display interface EtherChannel information.
(Optional) Display interface flowcontrol information
(Optional) Display interface trunk VTP pruning information.
(Optional) Display the input and output packets by switching path for the
interface.
(Optional) Display the status of the interface. A status of unsupported in the Type
field means that a non-Cisco small form-factor pluggable (SFP) module is inserted
in the module slot.
(Optional) Display interfaces in error-disabled state.
(Optional) Display the administrative and operational status of a switching port,
including port blocking and port protection settings.
(Optional) Display Flex Link backup interface configuration and status for the
specified interface or all interfaces on the switch.
(Optional) Display the physical properties of a CWDM
form-factor (SFP) module interface. The keywords have these meanings:
detail—(Optional) Display calibration properties, including high and low
•
numbers and any alarm information.
properties—(Optional) Display speed and duplex settings on an interface.
•
Chapter 2 Catalyst 2960 Switch Cisco IOS Commands
show interfaces counters command.
1 2
or DWDM small
OL-8604-04