Debug Ip Dhcp Snooping - Cisco Catalyst 2960 Command Reference Manual

debug ip dhcp snooping

debug ip dhcp snooping
To use this command, the switch must be running the LAN Base image.
Note
Use the debug ip dhcp snooping privileged EXEC command to enable debugging of DHCP snooping.
Use the no form of this command to disable debugging.
Syntax Description mac-address
agent
event
packet
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History Release
12.2(25)FX
Usage Guidelines The undebug ip dhcp snooping command is the same as the no debug ip dhcp snooping command.
Related Commands Command
show debugging
Catalyst 2960 Switch Command Reference
B-12
debug ip dhcp snooping {mac-address | agent | event | packet}
no debug ip dhcp snooping {mac-address | agent | event | packet}
Display debug messages for a DHCP packet with the specified MAC address.
Display debug messages for DHCP snooping agents.
Display debug messages for DHCP snooping events.
Display debug messages for DHCP snooping.
Modification
This command was introduced.
Appendix B
Description
Displays information about the types of debugging that are
enabled.
Catalyst 2960 Switch Debug Commands
OL-8604-04