Maintenance Procedures; Battery - HYOSUNG Prima Service Manual

2-3 MAINTENANCE PROCEDURE
MAINTENANCE PROCEDURE
This section describes the service procedures for
each section of the periodic maintenance.

BATTERY

NOTE:
Inspect Initial 1,000 km and Every 4,000 km.
● Remove the pillion seat for measure of battery voltage.
● Remove the battery � lead and then � lead at the
battery terminls and remove the battery.
● Using pocket tester, measure the battery voltage.
If the tester reading is less than 12.0V, recharge
the battery with a battery charger. ( Refer to page 5 - 13 )
Pocket tester : 09900 - 25002
Bettery voltage
Recharge
Standard charge
Fast charge
CAUTION
∙ W h e n r e c h a r g i n g t h e b a t t e r y r e m o v e
the battery from motorcycle.
O t h e r w i s e , r e g u l a t o r / r e c t i f i e r u n i t
should be an obstacle.
∙ W h e n r e c h a r g i n g t h e b a t t e r y , d o n o t
remove the caps.
∙ When recharging the battery, above the
charge electric current and time should
be kept as 12V.
Minimum 12.0V
0.4A×5~10 Hours
4A×30 Minutes