Throttle Cable Play - HYOSUNG Prima Service Manual

● Remove the air cleaner cover, separate the element.
● Fill a washing pan of a proper size with non-flammable
cleaning solvent. Immerse the element in the cleaning
solvent and wash them clean.
● Squeeze the cleaning solvent out of the washed ele-
ment by pressing it between the palms of both hands:
do not twist or wiring the element or if will develop
tears.
● Immerse the element in Hyosung genuine oil, and
squeeze the oil out of the element leaving it slightly
wet with oil.
● Fit the elements to the cleaner case properly.
CAUTION
∙Before and during the cleaning operation,
inspect the element for tears. A torn element
must be replaced.
∙Be sure to position the element snugly and cor-
rectly, so that no incoming air will bypass it.
Remember, rapid wear of piston rings and
cylinder bore is often caused by a defective or
poorly fitted element.

THROTTLE CABLE PLAY

NOTE:
Inspect Initial 1,000 km and Every 4,000 km.
● Loosen the lock nut ① and adjust the cable play �
by turning adjuster ② in or out to obtain the following
cable play. After adjusting play, tighten the lock nut.
Throttle cable play
0.5 ~ 1.0 mm
MAINTENANCE PROCEDURE 2-6
Non-flammable
cleaning solvent
�
� �
Inside
Hyosung
genuine oil
①
②