3-3 ENGINE
● Remove the engine mounting shaft and remove the
engine from the frame.
ENGINE REMOUNTING
The engine can be mounted in the reverse order of
removal.
● Install the damper to the crankcase bracket as shown
in the illustration.
● With " UP " mark faced upward, install the crankcase
bracket ① on the frame. Do not tighten the bracket
bolt ② at this stage. Pull up on the rear part of
crankcase bracket and while holding it, tighten the
bracket bolt ② to specification. Tighten both the rear
shock absorber bolt ④ and engine mounting bolt ③
to specification.
Engine mounting bracket bolt
Engine mounting bolt
Rear shock absorber bolt
: 48~72 N∙m (4.8~7.2 kg∙m)
: 40~60 N∙m (4.0~6.0 kg∙m)
: 22~35 N∙m (2.2~3.5 kg∙m)
Front side
①
" UP "
mark
Damper
②
③ ①
④
10mm
8mm