HYOSUNG Prima Service Manual page 65

3-37 ENGINE
● Install the movable drive face cover ① .
CAUTION
Make sure that the movable drive plate is fully
positioned inside, or the weight roller may come
off.
● Insert the spacer ② .
● Position the movable drive face subassembly on the
crankshaft as shown in the photo.
CAUTION
Thoroughly clean the V-belt contact to be from oil.
● Install the fixed drive face ③ .
● Tighten the kick starter driven nut ④ to the specified
torque with the special tool.
Conrod holder : 09910 - 20115
Kick starter driven nut : 40~60 N∙m (4.0~6.0 kg∙m)
● Fill SUPER GREASE " A " in the groove provided
inside sliding surface of the kick driven gear and
install it � on the end of the crankshaft. Wipe off
excess grease.
Super Grease " A "
● Install the spring � and spacer � .
①
③ ④
�
�
�
②
�