HYOSUNG Prima Service Manual page 96

● Insert the nozzles of the electrolyte container into the
battery' s electrolyte filler holes, holding the container
firmly so that it does not fall.
CAUTION
∙Take precaution not to allow any of the fluid to
spill.
∙The electrolyte container insert at right angles
so that it is not sloped.
● Make sure air bubbles are coming up each elec-
trolyte container, and leave in this position for about
more than 20 minutes.
NOTE:
If no air bubbles are coming up from a filler port, tap the
bottom of the two or three times.
Never remove the container from the battery.
● After confirming that the electrolyte has entered the
battery completely, remove the electrolyte containers
from the battery. Wait for around 20 minutes.
● Insert the caps ① into the filler holes, pressing in
firmly so that the top of the caps do not protrude
above the upper surface of the battery' s top cover.
CAUTION
∙Clean completely in case that the electrolyte is
adhered at the filler hole.
∙Once install the caps to the battery, do not
remove the caps.
ELECTRICAL SYSTEM 5-12