HYOSUNG Prima Service Manual page 101

6-3 CHASSIS
Drive out the both bearing with the special tool in the fol-
lowing procedures.
● Insert the adapter into the bearing.
● After inserting the wedge bar from the opposit side,
lock the wedge bar in the slit of the adapter.
● Drive out the bearing by knocking the wedge bar.
Wheel bearing remover : 09941 - 50111
CAUTION
The removed dust seal and bearing should be
replaced with new ones.
INSPECTION
WHEEL RIM
Make sure that the wheel rim runout does not exceed
the service limit when checked as shown.
An excessive runout is usually due to worn or loose
wheel bearings and can be reduced by replacing the
bearings. If bearing replacement fails to reduce the
runout, replace the wheel.
Wheel rim runout
(Axle and Radial)
Dial gauge(1/100 mm) : 09900 - 20606
Magnetic stand : 09900 - 20701
TIRE
Inspect the tires for wear and damage, and check the
tire tread depth as shown. Replace a badly worn or dam-
aged tire. A tire with its tread worn down to the limit(in
terms of tread depth)must be replaced.
Service limit 3.0 mm