Denso BHT-825QW User Manual page 185

BHT-825Q series
Setting up the master station
1.
Select "3: MASTER" in the SET BLUETOOTH menu and then press
the ENT key.
The current settings are displayed.
[1: PEER BD_ADDR]: Sets up the remote device address of the connection
[2: PASSKEY]:
[3: TIMEOUT]:
[4: SECURITY]:
Press the Backspace/clear key to return to the SET BLUETOOTH menu.
2.
Use the cursor keys ([▲] [▼]) or numeric keys ([1] [2] [3] [4]) to select
the menu and then press the ENT key.
Entry mode is activated and the cursor is displayed.
To set up the "4: SECURITY", use the cursor keys ([◄] [►]) to highlight and set the desired setting.
3.
Use the numeric and period (.) keys to enter the desired value.
"PEER BD ADDR";
"PASSKEY":
"TIMEOUT";
For the Bluetooth
®
Bluetooth wireless communications".
To switch the entry mode (between numeric and alphabet entries), press the SF key.
To delete a single character, press the Backspace/clear key. To delete the entire entry, press and hold
the Backspace/clear key or press the SF and Backspace/clear keys simultaneously.
4.
Press the ENT key.
5.
Press the Backspace/clear key to return the SET BLUETOOTH menu.
170
target.
Sets up the Bluetooth
station
Sets up the timeout period in seconds.
Sets up the security mode for the master station.
12-digit hexadecimal numbers only
The ENT key is not available until the twelfth digit is entered.
Up to 16 characters
Valid Range: 1–255, Default: 30 seconds
®
passkey and the security mode details, refer to "Chapter 5 Communication" – "5.3
®
passkey for the master