Denso BHT-825QW User Manual page 136

Setting the Code Scanning Test Options
When performing the code scanning test, press the F1 key to display the
screen on the right, allowing code scanning test options to be set.
The highlighted setting will be the current settting.
To make changes, use the cursor keys （[▲][▼]） or numerical keys （[1][2]）
to highlight the setting item, and then highlight the setting values using the
cursor keys ([◄] [►]).
Press the ENT key or BS/C key to return to the Code scanning test menu.
"1：READ SETTING"
Set the scanning conditions for code scanning test.
「DEFAULT」：Read under default scanning conditions.
「SYSTEM PARAMETER」：Specify scanning conditions with system setting values. Specifying
with the system setting value enables to set the detailed scanning conditions. Refer to the "The
function to assign scan settings with the system settings" in "4.5.6. [4] Setting the code scanning
parameters" for setting of the system setting value.
Codes that permit to read with "DEFAULT"settings
QR Code（model 1, model 2, Micro QR Code）
PDF417, Micro PDF417
MaxiCode
Data Matrix
Composite
EAN-13, UPC-A *1
EAN-8 * 2
UPC-E *1
Interleaved 2 of 5 （ITF） * 2
Codabar（NW-7）
Code 39
Code 93
Code 128、GS1-128（EAN-128）
RSS（GS1 DataBar）
*1: Exclude "with add-on"。
*2: The codes with more than 4 digits are read for ITF.
When EAN/UPC Code with add-on or multiline code is read under the code scanning test,
━ Point ━
set the system setting value prior to setting of the "SYSTEM PARAMETER"
"2：OUTPUT DATA(COM1)"
Under the code scanning test, code marks, digit numbers and the data, which are read from infared
communication ports when reading codes, are output. Use the values set at section 4.5.6 [5] "Setting
the communication environment" for the communication speed. The setting enables to limit the size of
the output data.
"100bytes"：Output data is limited to 100 bytes.
"ALL"： The data read are output entirely
：
：
2D Code Handy Terminal
121