Denso BHT-825QW User Manual page 116

[5] Setting the communication environment
The communication environment settings following system initialization are follows.
Do not change these settings unless necessary.
Interface port
Communication protocol
Infrared interface port
TRANSMIT SPEED
PROTOCOL
Use the following procedure if necessary to change the communication environment settings.
1.
Select "5: COMMUNICATION" at the SET SYSTEM menu and then
press the ENT key.
The SET COMMUNICATION menu screen on the right displays.
2.
Use the cursor keys ([▲] [▼]) or numerical keys ([1] [2]) to highlight
the item to be set and press the ENT key.
"1: OPTICAL":
Changes the infrared communication parameters.
"2: PROTOCOL TYPE":
Changes the communication protocol setting.
Refer to the following section for details of the above items.
Press the BS/C key to return to the SYSTEM MENU.
"1: OPTICAL": Infrared communication parameters
1.
Select "1: OPTICAL" at the SET COMMUNICATION menu and then
press the ENT key.
The SET OPTICAL menu screen on the right displays.
2.
Use the cursor keys ([▲] [▼]) or numerical keys ([1] [2]) to
highlight "1: PARAMETER" or "2: PROTOCOL", and then press the
ENT key.
Press the BS/C key
Item
Optical (infrared interface port)
Ymodem protocol
Baud rate 115200 bps
Protocol options SERIAL No.:
H. PARITY:
LINKUP TIME:
FIELD SPACE:
to return to the SET SYSTEM menu.
2D Code Handy Terminal
Default
ON (Adds serial numbers to data
blocks.)
ON (Adds horizontal parity.)
30 seconds
Ignore (Trim)
101