Denso BHT-825QW User Manual page 104

"1:QRCODE"：Detailed settings for QR Code
1.
Select "1:QRCODE" at SET 2D CODE menu and then press the ENT key.
SET QRCODE screen displays.
QR Code 1／2
（Concatenated QR code set）
"1：READING":
Enable/disable concatenated QR Code.
For QR Codes, there is a function where data is coded after being spilit into
a maximum of 16 segments and original data is restored when the codes
are read. These segmented codes are called concatenated codes.
"2：EDIT MODE"：
Set the scan mode of concatenated QR Code.
"EDIT": Edit mode
The data is stored in memory when all segmented codes have been read.
A reading error occurs if the volume of data exceeds 65,280 bytes. The
beeper sounds at 500 ms intervals, and all read data is discarded.
"BATCH": Batch edit mode
The data is stored in memory when all segmented codes within the scanning
field of view have been read.
"NON-EDIT": Unedited mode
The data is stored in memory each time a segmented code is read.
In edit mode, when the first code of the concatenated code is read the beeper sounds twice and the
system enters concatenated code reading status.
When subsequent concatenated codes are read the beeper sounds once. After the final code has
been read, the beeper sounds three times and reading is complete.
If QR codes other than concatenated codes are read during concatenated code reading
- Point -
then concatenated code reading ends, the read concatenated codes are discarded, and
the data for the last QR codes read is saved.
When the illuminating indicator LED is set to OFF in trigger switch operation (Auto-off
mode, Momentary mode, and alternate) or when the raeding of the next concatenated code
is not completed within approx. 3 seconds in modes other than Auto-off mode, the data
read so far is cleared and concatenated code reading ends.
When other concatenated codes are read before a concatenated code has been read
completely, the data read so far is cleared and reading begins on the new code.
2D Code Handy Terminal
Changeover
with[ ▲
]keys
][ ▼
89