Denso BHT-825QW User Manual page 133

BHT-825Q series
[1] Code scanning test
Use the following procedure to perform a barcode scanning test.
1.
Select "1: QRCODE" at the TEST menu and then press the ENT key.
The screen on the right displays.
2.
Scan a barcode or 2D with the BHT
Upon completion of barcode or 2D scanning, the speaker beeps once, and
the indicator LED turns blue.
3.
The scanned 2D code or barcode type, lead digits, total number of
digits, and code data display on the screen. Ensure that the code
data and screen display match.
Press the BS/C key to return to the TEST menu.
QR Code has a function where data is coded after being split into a maximum of 16 segments and
- Point -
the segmented codes are read. Codes segmented using this function are called concatenated codes.
When reading concatenated codes, the beeper works differently than with normal reading.
The beeper sounds twice when the first code of the concatenated code is rad, and the system enters
the concatenated code reading mode. When subsequent concatenated codes are read, the beeper
sounds once. After the final code has been read, the beeper sounds three times and reading is
complete.
The reading data screen display will not be shown until after concatenated code reading is complete.
If QR codes other than concatenated codes are read during concatenated code reading those codes
are displayed, the concatenated code reading mode is cancelled and the read concatenated codes are
discarded. This also happens if the trigger switch is released or the interval between reading of
concatenated codes is over 5 seconds.
The order for reading concatenated codes is arbitrary. The same concatenated codes will not be read it
again.
Option data is displayed at the end of the QR Code data when OPTION DATA is set to ON at the set
- Point -
code reading conditions screen of the SET SYSTEM menu. (Refer to "4.5.5 [4] Setting the code
reading conditions")
118
Code type
digitsnumbers
First
All digit numbers