Denso BHT-825QW User Manual page 130

[BLOCK ERASE ICON]
1.
Select "2: DRIVE TOOL" from the SET SYSTEM Menu 2/2 and then press the
ENT key to display the screen on the right. Select the "2: BLOCK ERASE ICON"
from the DRIVE TOOL screen and use the the cursor keys
ON/OFF.
Whole/partial user area sometimes needs to be reorganized during file writing
on the application or drive degragmentation and so on. During these times
(approx. 1 second) the application is suspended to display the hourglass icon
on the bottom-right corner. Whether to display the icon (ON) or not (OFF) can
be specifed.
[10] Setting the RPC
The BHT-800 series is compliant with the BHT Manager software (host-side tool). The RPC screen
displays the settings used to communicate with the BHT Manager software.
For details, refer to the "BHT Manager User's Manual". The following explains
only the operation of this menu and an outline of the settings.
1.
Select "8: RPC" from the SET SYSTEM Menu 1/2 and then press the
ENT key.
The SET RPC screen on the right will display.
The highlighted setting will be the current setting.
"1: TRANSPORT":
Selects the communication path for communicating with the BHT Manager.
"2: REMOTE WAKEUP":
Sets the PRC remote wakeup.
"3: SCHEDULED WAKEUP":
Sets the scheduled wakeup.
"4: TIMEOUT":
Sets the communication time out interval.
"5: DEVICE COM1":
Sets the COM port when a serial communication path is used.
"6: PORT":
Sets the port number for RPC.
"7: HOST ADDRESS":
Sets the BHT Manager HOST-IP.
"8: HOST PORT":
Sets the port number for the BHT Manager line connection notification.
2.
Use the cursor keys ([◄] [►]) to select each setting value.
3.
Press the ENT key.
The selected value will then be set.
2D Code Handy Terminal
([◄] [►])
to select
ENT key
Select items with
the [▲] and [▼] keys.
115