Signal During Run (Run) - Omron 3G3MX2 User Manual

5-9 Functions Relating to Protections, Warnings and Various Output Signals

Signal During RUN (RUN)

A signal is output by a multi-function output terminal or multi-function relay output terminal
while the Inverter is operating.
This signal turns ON only with Inverter output, and it is not output even when a RUN command
is issued by setting the frequency to 0 Hz. (The RUN lamp is lit when a RUN command is input.)
Allocate "00: RUN (During RUN)" to any Multi-function Output Terminal Selections (C021 to
C022) or Multi-function Relay Output Function Selection (C026).
Also outputs a signal during DC injection braking.
Below is the time chart. The RUN signal will remain ON until the motor stops, even when the
RUN command is turned OFF.
Parameter
C021 to
C022
C026
5
Output frequency
FW input
(forward)
RUN output
5-121
Function name
No.
Multi-function
Output Terminal
Selection
Multi-function
Relay Output
Function Selection
Data
00: RUN (During RUN)
SYSDRIVE MX2 Series USER'S MANUAL (3G3MX2-A@@@@)
Default
Unit
setting
− −