Name Of Parts Of The Digital Operator; Names Of Parts And Their Descriptions - Omron 3G3MX2 User Manual

3-1 Name of Parts of the Digital Operator

3-1 Name of Parts of the Digital Operator

Names of Parts and their Descriptions

RUN Command enabled
3
8.8.8.8.
3-1
8.8.8.8.
Data display
LED indicator
Operation key
Name
POWER LED
ALARM LED
PROGRAM LED
indicator
RUN (during
RUN) LED
indicator
Monitor LED
indicator (Hz)
Monitor LED
indicator (A)
RUN Command
enabled LED
indicator
Display
RUN key
STOP/RESET
key
Description
Lit (green) while the Inverter is receiving power.
Lit (red) when the Inverter trips.
For information on how to reset the trip, refer to "Method for
Resetting Trip" on page 7-1.
Lit (green) when the displayed data (set value) can be
changed.
Blinks if the set value is invalid. Refer to "Warning Display"
on page 7-7.
Lit (green) when the Inverter is running. (Lit when there is
either a "valid RUN command" or "inverter output."
Accordingly, it is also lit when a RUN command is issued at
a set frequency of 0 Hz or while the motor is decelerating
after the RUN command is turned OFF.)
Lit (green) when the displayed data is frequency.
Lit (green) when the displayed data is current.
Lit (green) when the RUN command is set to the Digital
Operator.
(The RUN key on the Digital Operator is enabled.)
Various parameters, frequency/set value and other data are
displayed (red).
Runs the Inverter. Take note that this key is enabled only
when the RUN command destination is the Digital Operator.
This key decelerates the Inverter to a stop. (Although the
STOP/RESET key is enabled even when a RUN command is
issued to a destination other than the Digital Operator (factory
default), it can be disabled by a Setting (b087).)
If the Inverter is already tripped, the trip will be reset (return
from the tripping).
SYSDRIVE MX2 Series USER'S MANUAL (3G3MX2-A@@@@)
USB connector
RJ45 connector