Table of Contents
Advertisement
Chapter 4. Quick Installation Guide
This chapter will show you how to configure the basic functions of your Wireless 3G Router using
Quick Setup within minutes.
A computer with wired Ethernet connection to the Wireless Router is required for the
first-time configuration.
4.1 Manual Network Setup - TCP/IP Configuration
The default IP address of the WNRT-617 is 192.168.1.1. And the default Subnet Mask is
255.255.255.0. These values can be changed as you desire. In this guide, we use all the default
values for description.
Connect the local PC to the LAN ports of the Router. And then you can configure the IP address for
your PC in the following two ways.
Obtain an IP address automatically
Configure the IP address manually
In the following sections, we'll introduce how to install and configure the TCP/IP correctly in Windows
XP. First, make sure your Ethernet Adapter is working, and refer to the Ethernet adapter's manual if
needed.
4.1.1 Obtain an IP Address Automatically
Summary:
Set up the TCP/IP Protocol in "Obtain an IP address automatically" mode on your PC.
Then the WNRT-617 built-in DHCP server will assign IP address to the PC automatically.
1.
Install TCP/IP component
On the Windows taskbar, click the Start button, point to Settings, and then click Control
1)
Panel.
Click the Network and Internet Connections icon, and then click on the Network
2)
Connections tab in the appearing window.
3)
Right click the icon shown below, select Properties on the prompt window.
User's Manual of WNRT-617
-11-
Advertisement
Table of Contents
