Configuration On The Machine - Xerox 4595 System Administration Manual

3. U s i ng C e nt r eWa r e I nt er n e t S er v i c e s

Configuration on the machine

3- 2
This section describes the configuration procedure for using
CentreWare Internet Services on the machine.
First enable the Internet service port, then set the IP address.
1. Display the System Administrator Menu screen.
a. Press the Log In/Out button.
b. Enter the UserID using the numeric keypad and then
select Confirm.
NOTE: The default User ID value is 11111. When using the
Authentication feature, a password is required. The default
password is x-admin.
c. Select System Settings.
Enable the Internet service port on the machine.
2.
a. Select System Settings.
b. Select Network Settings.
c. Select Port Settings.
d. Select Internet Service (HTTP) and then select Change
Settings.
e. Select Internet Service - Port and then select Change
Settings.
f. Select Enable and then select Save.
g. Select Close repeatedly until the Network Settings
screen is displayed.
3. Set the IP address.
If the IP address is already set, this step is not necessary.
Also, in an environment with DHCP or BOOTP, configure the
way to obtain the address. If the address cannot be obtained
automatically or manual configuration is preferred, configure
the IP address, subnet mask, and gateway address.
a. Select Protocol Settings.
b. Select TCP/IP - Get IP Address and then select Change
Settings.
c. Select one from DHCP, BOOTP, RARP, DHCP/Autonet or
Manual. If you select anything other than Manual, proceed
to step 4.
NOTE: When using a DHCP server, also configure the WINS
(Windows Internet Name Service) server.
d. Select TCP/IP - Get IP Address and then select Change
Settings.
e. Enter the IP address using the numeric keypad.
X e r o x 4 5 95 Co p ie r / P r in t er S y s te m Ad m i ni s t r at i on G ui d e