Millimeters/Inches; Keyboard Input Restriction; Operation Of Up/Down Buttons; Overwrite Hard Disk (Optional) - Xerox 4595 System Administration Manual

8. S e tu ps
8- 7 0

Millimeters/Inches

Select the default setting for displaying the dimensions on the
screen as millimeters or inches.

Keyboard Input Restriction

Select whether to restrict the display of the virtual keyboard on the
touch screen. To prevent illegible characters from occurring when
one character set is switched to another character set, restrict the
input to ASCII characters only. If you select On (Standard ASCII
only), the displayed keyboard shows ASCII characters only.

Operation of Up/Down Buttons

Select whether or not there is a continuous scrolling effect when
the scroll buttons are held down.
• Disable Fast Scrolling: Scrolling does not occur when the
scroll buttons are held down.
• Enable Fast Scrolling: Scrolling occurs when the scroll
buttons are held down.

Overwrite Hard Disk (optional)

KEY POINT: This is an optional accessory and may be purchased
at an additional cost to the customer. For more information,
contact the Customer Support Center.
If this option is available on your machine, you can select whether
or not to perform a hard disk overwrite process. If this option is
on, you can select whether to overwrite one time or three times.
After deleting data from the hard disk, the area on the hard disk
where the data was stored is overwritten. This prevents
unauthorized retrieval or restoration of the previously recorded
data. This applies to files and other information stored temporarily
by the system.
KEY POINT 1: A service representative can block changes to the
settings of this feature. For more information, refer to Service
Representative Operation Limit page 73.
KEY POINT 2: If the machine is powered off during the
overwriting process, some files may remain on the hard disk.
X e r o x 4 5 95 Co p ie r / P r in t er S y s te m Ad m i ni s t r at i on G ui d e