Configuration On The Computer - Xerox 4595 System Administration Manual

Configuration on the computer

Using with FTP
Using with SMB
X er o x 4 5 95 Co pi e r /P r i n te r S y s t em Ad m i ni s t r at i on G ui d e
NOTE 1: Enter address in the format "xxx.xxx.xxx.xxx"
where xxx should be a numeric value in the range from 0
to 255. However, 224 or 225.xxx.xxx.xxx and
127.xxx.xxx.xxx cannot be used.
NOTE 2: Specify the subnet mask by a combination of the
numbers 0, 128, 192, 224, 248, 252, and 255. However,
you cannot use 0 between non-zero values.
NOTE 3: If you do not wish to set the gateway address,
enter "0.0.0.0."
Select Close repeatedly until the System Settings screen is
5.
displayed.
Select Exit.
6.
After the machine is restarted, print out the Printer Settings
7.
List to confirm that either the SMB port or FTP client port is
enabled and the IP addresses are configured.
This section describes the configuration procedure for the
computer.
Create a destination directory/folder for your files. this directory/
folder should be created on the FPT server where you logged in.
Create a folder on the computer and configure it as a shared
folder.
5 . Us i n g th e S c a n Se r v i c e
5-23