Allocate Memory - Xerox 4595 System Administration Manual

Allocate Memory

X er o x 4 5 95 Co pi e r /P r i n te r S y s t em Ad m i ni s t r at i on G ui d e
Select the item to be set.
3.
For each interface, you can select the memory capacity for the
receiving buffer (temporary storage for data sent from the
client). You can change the receiving buffer capacity depending
on the pattern of use and purpose. Increasing the receiving buffer
capacity may allow a client to be released sooner from an
interface.
KEY POINT: If you change the memory capacity settings, the
memory is reset, and therefore data stored in all memory areas is
lost.
NOTE: It is not possible to assign more than the total memory.
When the power is turned on, if the settings exceed the available
memory capacity, they are automatically adjusted by the system.
From the System Settings screen, select Allocate Memory.
1.
2. Select the item to be set or changed, and select Change
Settings.
3. Select the desired value for that item.
Select Save; you are returned to the Print Mode Settings
4.
8 . S e t ups
8-125