Stamp Position Defaults - Xerox 4595 System Administration Manual

8. S e tu ps
8- 1 0 6

Stamp Position defaults

You can select the default position that the stamp is printed on the
output when the Stamp feature is selected on the Annotation
screen (Output Format tab). There are nine stamp position
defaults:
• Stamp Position - Top Left
• Stamp Position - Top Center
• Stamp Position - Top Right
• Stamp Position - Left Center
• Stamp Position - Center
• Stamp Position - Right Center
• Stamp Position - Bottom Left
• Stamp Position - Bottom Center
• Stamp Position - Bottom Right
Select a setting for each one of these stamp positions. When you
select a specific Stamp Position on the Annotation screen
(Output Format tab), such as Top Left, the setting selected here
defines exactly where on the top left of the output the stamp is
printed.
You can fine tune the default stamp position in both the horizontal
and vertical directions:
• For Top Left, you can set the horizontal position within a range
of 0-100 in 1 mm increments, and in the vertical position within
a range of 0-100 in 1 mm increments.
• For Top Center, you can set the horizontal position within a
range of 0-100 in 1 mm increments, and in the vertical position
within a range of 0-200 in 1 mm increments
• For Top Right, you can set the horizontal position within a
range of 0-100 in 1 mm increments, and in the vertical position
within a range of 0-100 in 1 mm increments
• For Left Center, you can set the horizontal position within a
range of 0-200 in 1 mm increments, and in the vertical position
within a range of 0-100 in 1 mm increments
• For Center, you can set the horizontal position within a range
of 0-200 in 1 mm increments, and in the vertical position within
a range of 0-200 in 1 mm increments
• For Right Center, you can set the horizontal position within a
range of 0-200 in 1 mm increments, and in the vertical position
within a range of 0-100 in 1 mm increments
X e r o x 4 5 95 Co p ie r / P r in t er S y s te m Ad m i ni s t r at i on G ui d e