Xerox 4595 System Administration Manual page 266

8. S e tu ps
Stamp Position-Left Center
Stamp Position-Center
Stamp Position- Right
Center
Stamp Position- Bottom
Stamp Position- Bottom
Center
8- 1 0 8
This feature allows you to fine tune exactly where on the left
center of the output that your stamp is printed. The selection
made here becomes the default setting when Left Center is
selected for the Stamp Position on the Annotation screen
(Output Format tab).
Set the position in the horizontal direction within the range 0-200
and in the vertical position within the range 0-100 in1 mm
increments.
This feature allows you to fine tune exactly where on the center of
the output that your stamp is printed. The selection made here
becomes the default setting when Center is selected for the
Stamp Position on the Annotation screen (Output Format tab).
Set the position in the horizontal direction within the range 0-200
and in the vertical position within the range 0-200 in 1 mm
increments.
This feature allows you to fine tune exactly where on the right
center of the output that your stamp is printed. The selection
made here becomes the default setting when Right Center is
selected for the Stamp Position on the Annotation screen
(Output Format tab).
Set the position in the horizontal direction within the range 0-200
and in the vertical position within the range 0-100 in 1 mm
increments.
This feature allows you to fine tune exactly where on the bottom
left of the output that your stamp is printed. The selection made
Left
here becomes the default setting when Bottom Left is selected
for the Stamp Position on the Annotation screen (Output
Format tab).
Set the position in the horizontal direction within the range 0-100
and in the vertical position within the range 0-100 in 1 mm
increments.
This feature allows you to fine tune exactly where on the bottom
center of the output that your stamp is printed. The selection
made here becomes the default setting when Bottom Center is
selected for the Stamp Position on the Annotation screen
(Output Format tab).
Set the position in the horizontal direction within the range 0-100
and in the vertical position within the range 0-200 in 1 mm
increments.
X e r o x 4 5 95 Co p ie r / P r in t er S y s te m Ad m i ni s t r at i on G ui d e