Configuration; Tcp/Ip (Lpd/Port 9100); Preparations; Configuration Procedure - Xerox D95 System Administration Manual

2

Configuration

TCP/IP (LPD/Port 9100)

Preparations

A network environment where TCP/IP is used is required when using the TCP/IP (LPD/Port
9100) protocol on the machine.

Configuration procedure

The machine can be connected to computers using the TCP/IP (LPD/Port 9100) protocol.
The following is the procedure to use TCP/IP(LPD/Port 9100) protocol.
• Configuration on the Machine: Configure TCP/IP (LPD/Port 9100) on the machine.
• Configuration on the Computer: Install the print driver.

Configuration on the machine (LPD)

This section describes the configuration procedure to use TCP/IP (LPD/Port 9100) protocol
on the machine. Enable the LPD Port or Port 9100 port, then assign the IP address.
LPR/LPD is a platform-independent printing protocol that runs over TCP/IP. Line Printer
Daemon (LPD) refers to the process that accepts print jobs from the line printer daemon
(LPR) client. This is analogous to the printer software and is often called LPD server.
The print server waits for the client to send a job. A print server may be capable of
handling multiple printers and print queues simultaneously. A queue name usually has
a single IP address, so it must be used to specify the intended print queue.
Note
The configuration can also be performed using CentreWare Internet Services. Refer to
Using CentreWare Internet Services.
Xerox ® D95/D110/D125/D136 Copier/Printer 2-1
System Administration Guide