Xerox 4595 System Administration Manual page 84

4. E - m a i l
4- 4
Enable the ports which are used for the e-mail feature.
2.
a. Select System Settings
b. Select Network Settings.
c. Select Port Settings.
d. Enable Send E-Mail - Port setting to use mail print.
e. Enable Receive E-Mail - Port setting to use mail print.
f. Enable Mail Notice - Port to use mail notice or job
completion notice.
g. Select Close repeatedly until the Network Settings
screen is displayed.
3. Set the IP address.
If the IP address is already set, this step is not necessary.
Also, in an environment with DHCP or BOOTP, configure the
way to obtain the address. If the address cannot be obtained
automatically or manual configuration is preferred, configure
the IP address, subnet mask, and gateway address.
a. Select Close repeatedly until the Network Settings
screen is displayed.
b. Select Protocol Settings.
c. Select TCP/IP - Get IP Address and select Change
Settings.
d. Select one from DHCP, BOOTP, RARP, DHCP/Autonet or
Manual. If you select anything other than Manual, proceed
to step 4.
NOTE: When using a DHCP server, also configure the
WINS (Windows Internet Name Service) server.
e. Select TCP/IP - Get IP Address and select Change
Settings.
f. Enter the IP address using the numeric keypad.
X e r o x 4 5 95 Co p ie r / P r in t er S y s te m Ad m i ni s t r at i on G ui d e