Document Scanner Unit / Document Cover (Only For Models Without Adf Unit) - Brother DCP-1510 Service Manual

7.4

Document scanner unit / Document cover (only for models without ADF unit)

(1) Open the document scanner unit.
(2) Disconnect the CIS flat cable, the document scanner motor harness, and the panel flat
cable from the main PCB ASSY, then pull out the CIS flat cable from the hole.
(3) Release the hook of the pull-arm, and remove it from the document scanner unit.
(4) Open the document scanner unit 90 degrees and remove it by pulling it up.
(5) Remove the two taptite bind B M4x12 screws. Release the four hooks of the panel unit.
Disconnect the panel flat cable from the panel PCB ASSY to remove the panel unit from
the document scanner unit.
(6) Remove the two taptite pan B M4x14 screws to remove the document cover from the
document scanner unit (only for models without ADF unit).
(7) Remove the hinge from the document cover by tilting it 120 degrees (only for models
without ADF unit). (2 locations)
Panel unit
Taptite bind B M4x12
Document
scanner unit
90°
Taptite pan B M4x14
(only for models without ADF unit)
Document
scanner unit
Pull-arm
Harness routing: Refer to
/ fuser unit" and
Panel flat cable
Hooks
Hook
Pull-arm
"1. Frame R / main PCB ASSY / low voltage power supply PCB unit
"5. Panel flat cable".
Panel PCB ASSY
Hole
Main PCB ASSY
Fig. 2-16
2-21
Hinges (only for models
without ADF unit)
Document
cover
(only for
models
without
ADF unit)
120°
Document scanner
motor harness
CIS flat cable
Panel flat cable
Confidential