Leds; Front Panel Leds - HP Integrity rx2800 i4 User Manual

LEDs

Front panel LEDs

Figure 22 Front panel LEDs and buttons
UID LED and button
1
Table 14 Front panel controls
Name Function
UID button This button helps locate a particular server within
a rack of servers. You can remotely activate this
function through various system utilities.
System This LED provides information about the system
health LED status.
Power This button manually powers the server on and off.
button
The front panel of the system contains the power button/system power LED, health LED, System
Event Log LED, and locator switch/LED. The server use flashing states (for example, flashing amber
or red) on these LEDs to indicate a warning or an error.
HP Confidential
System health LED
2
Power button
3
Status
Blue = Identification
Flashing blue = Remote iLO session or a
firmware flash update is in progress
Off = Off
Green = Health good on all internal FRUs and
system firmware has passed "BOOT_START"
Flashing Amber = A FRU or subsystem has failed,
or a fatal fault has occurred (system is on or in
standby mode).
Flashing Red = A fatal fault has been detected
and a FRU or subsystem has failed. View the
SID, other LEDs, and the logs for information.
Off = Health good on all internal FRUs and
system off
NOTE: The System Health LED does not change
status if AC power is removed from a single power
supply in a system with power redundancy.
Green = System on
Amber = System is powered off, but standby
power is on
Off = System power and standby power is off
Troubleshooting tools 65