Removing And Replacing A Half-Length Expansion Board - HP Integrity rx2800 i4 User Manual

Table 43 PCI slot descriptions (continued)
4 — Full length, full height
5 — Low profile
6 — Low profile
The server supports up to two PCIe riser boards. Each PCIe riser board holds up to three PCIe cards
each. The standard riser board configuration contains one riser board with one full-length, full-height
PCIe x8 slot, and two half-length, full-height PCIe x4 slots. The second board contains one full-length,
full-height PCIe x8 slot, and two half-length, half-height PCIe x4 slots.
The optional riser board configuration contains one riser board with one full-length, full-height PCIe
x8 slot, and two half-length, full-height PCIe x4 slots. The second board contains one full-length,
full-height PCIe x16 slot.

Removing and replacing a half-length expansion board

1. Power off the server
2. Extend the server from the rack
3. Remove the access panel
4. Disconnect any external cables that are connected to the expansion board.
5. Remove the PCI riser cage
6. Disconnect any internal cables that are connected to the expansion board.
1 12 Removal and replacement procedures
3–slot PCIe riser
PCIe2 x16 (8, 4, 2, 1)
PCIe2 x8 (4, 2, 1)
PCIe2 x8 (4, 2, 1)
("Powering off the server" (page
("Extending the server from the rack" (page
("Removing and replacing the access panel" (page
("Removing and replacing the PCI riser cage" (page
2–slot PCIe riser
PCIe2 x16 (8, 4, 2, 1)
PCIe2 x16 (8, 4, 2, 1)
—
99)).
95)).
106)).
111)).
HP Confidential