Memory Loading Rules And Guidelines; Installing Dimms - HP Integrity rx2800 i4 User Manual

Memory loading rules and guidelines

CAUTION:
Only ECC DIMMs are supported.
Load DIMM pairs from largest to smallest capacity. For example, if you have a pair of 4 GB
DIMMs and a pair of 8 GB DIMMs, install the pair of 8 GB DIMMs first.
NOTE:
channel, but faster DIMMs operate at the timing of the slowest DIMM populated.
Alternate loading between installed processors. Do not install DIMMs if the corresponding
processor is not installed.
Spread DIMMs evenly between processors.
Load DIMMs in pairs by increasing letter.
For best performance, install DIMM pairs in the specified sequence shown in
can be loaded in an economic order, for example, loading the first riser full before loading
DIMMs on other memory risers, but the DIMMs must still follow the basic DIMM load sequence.
◦
Load highest density DIMMs first.
◦
Load DIMMs in pairs by increasing letter.
Mixed DIMM types are supported with the following qualifications:
◦
DIMMs with x4 and x8 modes can be mixed.
◦
DIMMs with different sizes can be mixed.
◦
DIMMs with different rows, columns, bank, and rank numbers can be mixed.
◦
Do not mix unbuffered DIMMs with registered DIMMs.
◦
A maximum of two unbuffered DIMMs per channel can be installed.
◦
If quad-rank DIMMs are installed for a processor, a maximum of two DIMMs can be
installed on each channel for that processor.
◦
If a channel contains quad-rank DIMMs, the quad-rank DIMM must be installed first on
the channel.

Installing DIMMs

1. Remove the access panel. See
2. Lift the memory riser handle and remove the component.
48 Optional components
Failure to observe the following cautions results in system degradation or failure:
Faster DIMMs and slower DIMMs can be installed on different slots within the same
"Removing the access panel" (page
Table 9. DIMMs
42).
HP Confidential