Removing And Replacing A Power Supply Blank; Removing And Replacing A Hot-Swap Power Supply - HP Integrity rx2800 i4 User Manual

3. Remove the hard drive.
To replace the component, see

Removing and replacing a power supply blank

CAUTION:
all bays are populated with either a component or a blank.
To remove the component:
Figure 38 Removing the blank
To replace the component, reverse the removal procedure.

Removing and replacing a hot-swap power supply

The server supports 1+1 redundant power supply for high line (1200W/200~240VAC) and low
line (800W/100~120VAC) in the data center and office-friendly server versions.
Table 42 Power redundancy configurations
Line voltage
High Line (200-240)
High Line (200-240)
Low Line (100- 1 20)
Low Line (100- 1 20)
Low Line (100- 1 20)
HP Confidential
"Installing a hot-pluggable SAS hard drive" (page
To prevent improper cooling and thermal damage, do not operate the server unless
Power supply count
1
2
1
2
2
Processor count DIMM count
1 or 2 2 to 24
1 or 2 2 to 24
1 or 2 2 to 12
1 2 to 12
2 2 to 8
Removing and replacing a power supply blank 105
40).
Redundancy
No
Yes
No
Yes
1
Yes