Customer Messaging Policy - HP Integrity rx2800 i4 User Manual

Both Boxboro and ICH have an IOxAPIC, and both are used for the PCI devices underneath
Boxboro. The ICH's IOxAPIC range begins at 0xFEC00000, and Boxboro's begins at
0xFEC40000.
6. Hides unused devices from the OS by setting the appropriate ICH registers.

Customer messaging policy

See the SEL for any action from low level I/O subsystem faults, because the System Insight
Display may not have any illuminated LEDs.
For configuration-type errors, for example, no iLO 3 MP or core I/O HBAs installed or working,
see "Supported configurations" (page 75)
Some diagnostic messages are reported for high level I/O subsystem errors. All fatal I/O
subsystem errors cause global MCAs.
Table 36 I/O subsystem events that light SID LEDs
Diagnostic
LEDs
I/O Card
I/O Riser
Disk Backplane
Table 37 I/O card events that might illuminate SID LEDs
Diagnostic
LEDs
I/O Card
I/O Card
I/O Card
I/O Card
I/O Card
86 Troubleshooting
Sample IPMI events
Type 02h, 03h:05h:01h
CURRENT_LIMIT_EXCEEDED
Type 02h, 02h:07h:03h
VOLTAGE_DEGRADES_TO_NON_RECOVERABLE
Type 02h, 02h:07h:03h
VOLTAGE_DEGRADES_TO_NON_RECOVERABLE
Sample IPMI Events
Type E0h, 4658d:26d
IO_PCI_POWER_OVERLOAD_ERR
Type E0h, 137d:26d
IO_NOT_ENOUGH_POWER_ERROR
Type E0h, 147d:26d
IO_SLOT_STANDBY_POWER_ERROR
Type E0h, 131d:26d
IO_HOT_PLUG_CTRL_FAILED
Type E0h, 139d:26d
IO_PCI_MAPPING_TOO_BIG
for actions.
Cause
Over-current on PCI slot
Voltage on CRU is
inadequate
Voltage on CRU is
inadequate
Cause
A non hot plug I/O slot
power consumption
increases the total I/O
power consumption
beyond the supported
limit
Insufficient power to
power on a hot-plug
PCI-X slot
PCI slot standby power
failed
PCI-X hot-plug controller
failed
PCI bus walk (I/O
discovery) resources
exceeded
Source Notes
iLO MP Likely a short on
I/O card or I/O
slot.
iLO MP A voltage on the
I/O riser is out of
range (likely too
low)
iLO MP A voltage on the
disk backplane is
out of range
(likely too low)
Source Notes
SFW Disallow O/S
boot and display
the following
UEFI error
message, "I/O
configuration
exceed"
SFW Display UEFI
warning message
"Failed I/O slots
deconfigured"
SFW Either a card /
slot issue. Re-seat
card first.
SFW Either a card /
slot issue. Re-seat
card first.
SFW Remove any
unsupported I/O
cards. Move I/O
card to an
unused PCI slot
HP Confidential