Removing And Replacing The Access Panel - HP Integrity rx2800 i4 User Manual

1
A maximum of 8 DIMMs are supported in a configuration with low line AC voltage and 2 processors.
NOTE: Configurations other than those listed in
redundancy and are not supported.
Power redundancy is dependent on the number of power supplies, processors, and DIMMs in a
system. Additional components, such as HDDs or PCIe cards, do not impact power redundancy.
The server also supports power capping. Power capping operation can be observed through iLO
3. For more information, see the HP Integrity iLO 3 Operations Guide.
WARNING!
power supply blank to cool before touching it.
CAUTION:
all bays are populated with either a component or a blank.
To remove the component:
1. Determine how many hot-swap power supplies are installed:
If only one hot-swap power supply is installed, power off and remove the power cord
from the server
If more than one hot-swap power supply is installed, continue with the next step.
2. Access the product rear panel
3. Disconnect the power cord from the power supply.
4. Remove the hot-swap power supply.
WARNING!
the power cord to the power supply until the power supply is installed.
To replace the component, see

Removing and replacing the access panel

To remove the access panel see
To replace the component, reverse the removal procedure.
106 Removal and replacement procedures
To reduce the risk of personal injury from hot surfaces, allow the power supply or
To prevent improper cooling and thermal damage, do not operate the server unless
("Powering off the server" (page
("Accessing the product rear panel" (page
To reduce the risk of electric shock or damage to the equipment, do not connect
"Installing a hot-swappable power supply" (page
"Removing the access panel" (page
Table 42 (page 105) do not have 1+1 power
99)).
42).
103)).
41).
HP Confidential