Expansion Boards; Half-Length Expansion Board; Full Length Expansion Board - HP ProLiant DL560 Gen8 Maintenance And Service Manual

Expansion boards

Half-length expansion board

WARNING:
remove the power cord to remove power from the server. The front panel Power On/Standby
button does not completely shut off system power. Portions of the power supply and some internal
circuitry remain active until AC power is removed.
To remove the component:
Power down the server (on page 25).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Extend the server from the rack (on page 25).
3.
Remove the access panel
4.
Disconnect any external cables that are connected to the expansion board.
5.
Disconnect any internal cables that are connected to the expansion board.
6.
Remove the PCIe riser cage
7.
Remove the expansion board.
8.
To replace the component, reverse the removal procedure.

Full length expansion board

WARNING:
remove the power cord to remove power from the server. The front panel Power On/Standby
button does not completely shut off system power. Portions of the power supply and some internal
circuitry remain active until AC power is removed.
To reduce the risk of personal injury, electric shock, or damage to the equipment,
("Access panel" on page 29).
("PCIe riser cage
To reduce the risk of personal injury, electric shock, or damage to the equipment,
(primary)" on page 31).
Removal and replacement procedures 47