Oce 9400-II User Manual page 43

Place the roll holder with the material in the drawer (see figure 12).
6
[12] Repositioning the roll
Feed the material between the input guide plates against the rollers.
7
Turn the rollers until the material is visible (see figure 13). Also refer to the
8
sticker inside the drawer.
[13] Feeding the material
If you have inserted a roll with another material or with a different width, you
9
have to program the correct width and material type (refer to 'Programming
media settings' on page 48).
If you want to cut the paper to get a straight leading edge refer to 'Cutting the
paper to get a straight leading edge' on page 44.
Otherwise continue with the next step.
Close the drawer.
10
Press the button 'Cancel/Continue'.
11
(Re)load media and toner 43