UTP (Unshielded Twisted pair) cable looks much like standard phone cable.
The cable should have RJ45 plugs.
If you are using the ethernet port you need to configure a list of parameters. In
the following procedures all parameters are described.
Connecting Ethernet
Connect one end of the Ethernet cable to the computer's Ethernet port.
1
Connect the other end to the printer's Ethernet port (see figure 8).
2
[8] Ethernet port
Setting up the TCP/IP protocol
You have to configure the printer IP address, subnet mask and default gateway
IP address (check with your local administrator) Each of these four addresses
are composed of 4 numeric field ranging from 0 to 255. E.g. 194.2.66.146 or
255.255.255.0. On the menu the following order is presented field 0, field 1,
field 2, field 3.
Press 'Program' to enter the main menu.
1
Select the 'C
2
Press 'next/select' to enter the '
3
Select the 'C
4
Press 'next/select' to enter the '
5
Select the '
6
Press 'next/select' to enter the '
7
Select the '
8
Press 'next/select' to enter the '
9
Select the '
10
Press 'next/select' to enter the '
11
Enter the number of '
12
28
Océ 9400-II User Manual
RJ45
' menu using the
ONFIGURATION
' menu using the
ONNECTIONS
' item using the
ETHERNET
' menu using the
IP ADDRESS
0' menu using the
FIELD
0' of your '
FIELD
or
' menu.
CONFIGURATION
or
' menu.
CONNECTION
or
button.
' menu.
ETHERNET
or
button.
' menu.
IP ADDRESS
or
button.
0' menu.
FIELD
' using the
IP ADDRESS
button.
button.
or
button.