SCSI-2
If you are using the SCSI-2 port (for the scan to file option), you need to
configure two parameters; the SCSI-2 ID and the terminator.
The SCSI-2 port is used only for the scan to file option to upload data
Note:
from the controller to the connected PC.
Connecting SCSI-2
Switch off the printer and the host.
1
Connect one end of the SCSI-2 cable to the computer's SCSI-2 port.
2
Connect the other end to the printer's SCSI-2 port (see figure 6).
3
[6] SCSI-2 port
Switch on the printer and the host.
4
Installation of the printer
SCSI
25