Oce 9400-II User Manual page 46

Feed the material between the input guide plates against the rollers.Turn the
7
rollers until the material is visible (see figure 17). Also refer to the sticker
inside the drawer.
[17] Feeding the material
If you have inserted a roll with another material or with a different width, you
8
have to program the correct width and material type (refer to 'Programming
media settings' on page 48).
If you want to cut the paper to get a straight leading edge refer to 'Cutting the
paper to get a straight leading edge' on page 44.
Otherwise continue with the next step.
Close the lower paper compartment.
9
Press the button 'Cancel/Continue'.
10
46 Océ 9400-II User Manual